Polygons are created based on the location attribute. Select the attribute(s) to draw the polygon(s) for Group Field(s), that is, LOCATION.Usage Each polygon feature has its boundary profiled along the surface. This creates the smallest convex polygon enclosing all point features.Ī convex polygon is a polygon with interior angles of less than 180 degrees. Creates surface-conforming multipatch features by draping polygon features over a surface. Select Convex hull from the drop-down list for Geometry Type. To create multipart features from existing polygons by aggregating them based on attributes, you can use the Editor > Merge command (produces multipart polygons when the selected polygons are not contiguous) or the Dissolve geoprocessing tool, and specify that the output have multipart polygons. Select the polygon and use Cut polygon Tool to draw the polygon you want Before finish the sketched polygon, you need to to enable Snap to Sketch in the snapping toolbar to close the sketched polygon properly, then hit F2 or finish sketch, as you can see below: Then select the polygon you drew in step 2 and hit delete, and save edits.Select the layer containing the points data for Input Features, that is, VolcanoJapan.Configure the parameters in the Minimum Bounding Geometry pane.Search for the Minimum Bounding Geometry (Data Management) tool and click it. ![]()
0 Comments
Leave a Reply. |